Kel-tec Sub 2000 Gen2 9mm (Glock 17 Mags) - $369

I received my rebate verification email March 26, 2023. I still have not received my rebate. I'll never buy another Keltec. RipOFF

Guns and other types of equipment can be dealer on this forum you can easily buy it. All I want to tell is essay lab reviews that are concerning the new views.

So do you have to own a glock to use this or is that part built into the gun.

$408.99 shipped as of 7/5/18. 5 in stock. Not too bad, but will likely go fast.

This isn't overpriced. You're lucky to even find these in stock. I don't fault this shop for pricing it at what every other place does.

I cannot recommend the Gen2. The front sights are defective from the factory. you will have to send the gun back as soon as you get one. My front sight post is all the way down and all the way to the right and it still shoots a foot low and 9 inches right at 15 yards. I should have kept my Gen1. It was always dead-on.

Whittaker guns gets these in every couple months and sells them for $382 shipped. Don't give your money to these gougers.

I have less than $499 in my g19 sub 2000 AND 500 rounds of ammo

People are selling these for $550-$600 since they are hard to find.

Yeah 500 is a bit steep. I owned one and sold it, really wish I had held onto it. 350 to 400 I think is where they should be. But people will pay close to 500 for a Poly handgun, this isn't far away from there. Quality was fair.

$350 carbine. don't let the hype scare you into buying one. trump is president... give it about 6 months and these will be $300

Fire one of these before you pay $500 for one. Yes they are cool but are uncomfortable to shoot, the trigger sucks, a pain to clean, and you are pretty much limited to the iron sights that come on it if you want to be able to fold it in half. They are super light and compact for sure. Buy a $500-$600 AR-9 (I like the colt smg platform) and pull the two pins to store it in a bag if you need it compact. Then you can put a short range scope/red dot on it as well! crazy right? Easily cleanable and mine runs awesome.

It's really sad how much shop will over charge for these. but then again you have people climbing over each other to pay it.

I was lucky to have purchased one for $399 delivered last year.
However, I bought it with the express intent of tricking it out, as can be seen in my pic.
I got the 9mm S&W model 'cause it was way cheaper than the Glock and, as I already had a S&W 5906, I had mags that were interchangeable, further saving me $$ for my mods.
I saw many vids on it in it's original configuration and, after watching what mods others had done, I realized I could have a 9mm carbine for about $700-$800 with all the mods and add-ons I did.
I've been able to pick up many 15/20 rd mags for cheap and, even purchased 4 - 32 rd mags for throwing lots 'O lead down range.
Saw the new version at my local gun show and they did cosmetically change the forend a little, but ya still have to hold the damn thing on your face to see through the back site....OUCH.! Hence, I went for the Red Lion articulating forend, which indexes 45 degrees so I can still fold the gun in half and, it allows for an array of rails to be installed so you can attach what you need for your particular use.
A 3x9x50 UTG scope, is great for close up and distance accuracy out to 100 yds, along with a 5mw green laser.
9mm is still available for cheap prices and so far, I've loaded up with about 6K rds.
Just an FYI....this thing does not like aluminum cased ammo. I've seen vids of people using it,.... mine hates it...will not feed.
All in all, this is the least expensive 9mm carbine I've seen that's any good. Easy to clean and carry and, very accurate. In my mind, much better than the High Point and better than the Beretta,...which may look cool, but the stock is junk.!
Besides, I think my KelTec now looks way cooler....YMMV
The only other 9mm I considered was the HK, buttttt....at $2k plus, wasn't really an option. Even the knock off copies were approaching $2K.
All in all, I believe anyone would be happy with this carbine, especially if you modified it, making it easier to shoot and acquire your target.

Hello porciniman could you please send me pictures of your Carbine I really like it! And if you would be so kind tell me the parts you have added!

Not CA is it?...(sob)

By price, this is NOT a deal. However, having said that, this exact rifle in 9mm that takes Glock mags is the unicorn of rifles. I have only ever seen one in person once, couple years ago.

It should be noted that the second gen is coming out shortly. Different manufacturing process that moves the serialized "receiver" portion back towards the recoil spring tube (plus less manually scrubbing the excessive material from the parting line after molding.)

If you want this rifle, you will not find it on the internet for any kind of deal. Your best bet is to pay the over MSRP price like this or get lucky at an LGS.

Upvoted because the Sub2K in 9mm has been "as rare as hen's teeth." The 40S&W version is easier to find and likely cheaper.